What are the precautions for the operation and production of plastic granulators?

The following points should be noted in the operation and production of plastic granulators：

The following points should be noted in the production and operation of plastic granulators The correct operation of plastic granulators can extend the service life of the equipment. However, the use of plastic granulators is not given enough attention in our daily lives, and it will also cause some unnecessary problems. The following points need to be kept in mind.

1. Pay attention to fire safety. Fire extinguishers must be placed around plastic granulators during production.

2. Do not use low-quality return materials with metal impurities or mud (it is best to add a feeding iron remover to remove iron from plastics during feeding). Metal objects that may fall in should not be placed near the feed port to prevent them from falling into the hopper to aggravate the wear of the screw and barrel or cause jamming and damage.

3. In the event of a malfunction or abnormal situation, the relevant personnel must be reported and handled by professional maintenance personnel. If any abnormal phenomenon that affects safety is found, immediately press the emergency stop switch to cut off the power supply.

4. When operating plastic machinery, strictly follow the operating procedures and do not operate in violation of regulations at non-operating stations. To ensure the reliability of the safety device, the safety protection measures of the machine must not be destroyed in pursuit of efficiency.

5. The gearbox of the plastic granulator should pay attention to the lubricating oil that meets the requirements and be replaced regularly.

6. Operators who are trained and familiar with the structural performance and operating procedures of the plastic machinery should operate it.

7. During the production and operation of the plastic granulator, if the plastic temperature does not reach the set temperature and the insulation time is insufficient, the screw is not allowed to be started.

Proficiently mastering the above seven precautions can greatly reduce mechanical failures and mechanical damage caused by incorrect operation, and greatly extend the service life, stability and safety of the machine.